By Pbott
Formula:
Skin 1, Color 3, Color (-93, 9), Shade (12)
Facial Hair 72, Color (-99, 9), Shade (0), Trans (100)
Attire (Order is important. Entrance attire is match attire)
Tattoos (They are not exact, but they’re very close in shape)
Long Hemline 8, 1, 1, Color (100, -100), Shade (100), Trans (100), Length
(3)
Flames on the sleeves
The Three B Logo
Flames on the sides
Body Model
Figure Form:
Head Model
---------------
Face 18, Model 18
Figure (0, 0)
Shape (0, 0)
Age (28)
Head (-16, -32)
Eyebrow (0, 22)
Eyes – Left (-8, 0), Right (-15, -10)
Nose – Left (-26, -11), Right (-22, 0)
Cheek (100)
Mouth (0, 0), Right (-48)
Jaw – Left (100, 35), Right (25)
Eyes 15, Color (-100, 9), Shade (0)
Eyebrows 48, Color (-86, 12), Shade (0)
Lips Unpainted
Hair 19, Color (97, 9), Shade (-19)
Facial Hair 67, Color (-98, 9), Shade (0), Trans (100)
------------------------------------
Tights 2, 1, Color (40, -79), Shade (-100), Trans (100), Length (-100)
Wrist Bands (both) 1, 13, Color (-68, 9), Shade (-100), Trans (100),
Length (100)
Shoes 1, 1, 1, Color (100, -100), Shade (0), Length (2)
------------------------------------------------------------
Design, Simple, Right Arm, 61, Do not rotate, Enlarge one size up from
smallest reduction, place on outside of arm above the elbow. Color (23,
9), Shade (0), Trans (-34)
Design, Simple, Right Arm, 36, Do not rotate, Enlarge one size up from
smallest reduction, place on outside of forearm above the wristbands. Color
(23, 9), Shade (0), Trans (-34)
Design, Simple, Left Arm, 47, Do not rotate, Enlarge one size up from
smallest reduction, place on outside of forearm above the wristbands. Color
(23, 9), Shade (0), Trans (-34)
--------------------------
These pictures essentially wrap around the short sleeves of the above
shirt.
- Design, Picture, Right Arm, 83, Do not rotate, Enlarge one size up
from smallest reduction, place on sleeve so bottom of picture is on edge
of sleeve and before the skin, and side of picture is aligned with middle
of shoulder. Color (-78, 0), Shade (0), Trans (100)
- Design, Picture, Right Arm, 83, Do not rotate, Enlarge one size up
from smallest reduction, place on sleeve so bottom of picture is on edge
of sleeve and before the skin, and side of picture is aligned with middle
of shoulder but in opposite direction of the first picture. Color (-78,
0), Shade (0), Trans (100)
- It should look like the two pictures have completely wrapped around
the arm, however, there will be just a couple of pixels under the arm that
are left uncovered. It’s up to you if you want to place the following simple
design here to cover it up completely. You may want to go into form and
set the shoulder width to the maximum so you can see this space.
- Design, Simple, Right Arm, 153, Rotate once, Smallest reduction,
place in between the two above pictures so that it covers up the black
spot they failed to cover. Color (-85, 71), Shade (0), Trans (100)
- Repeat the above steps to put the flames on the left arm sleeves.
----------------------
All of the B’s are Design, Letter, Body, Alphabet 11
- First B - Enlarge three sizes up from smallest reduction.
- Second B – Enlarge three sizes up from smallest reduction, Rotate
twice so it’s a mirror image of the first B, place so B’s are connected
by the top and bottom edges.
- Third (top) B – Enlarge two sizes up from smallest reduction, Rotate
three times, place so it’s centered above the two connected B’s but disconnected
them by one pixel(up once on the pad).
- Color (-85, 9), Shade (0), Trans (100)
- It probably won’t be centered on the chest when you first enter it.
You can center the emblem on the chest by going in and editing through
the layer list, which will allow you to move the whole logo as one unit.
-----------------------
This isn’t an exact science, but it’s not rocket science either. The
idea is to keep the flames symmetrical so the dark half of the picture
shows on the front and the bright half shows on the back. You also want
to keep the flames connected as they go down the side of the outfit, and
you don’t want the flames touching the 3B logo. Use my pictures as a guide,
but just keep in mind that it doesn’t have to be exact, it just has to
look good. Since there are 5 designs, you should have enough leeway to
adjust a flame upward so that the flow of one into the other looks right.
When you’re finished, you should be right above the boots.
- There are exactly 5 designs on each side of the outfit going down,
but they’re not all the same size. The first three are two sizes up from
smallest reduction and mainly on the body, the last two are one size up
from smallest reduction and completely on the leg.
- This is the item to be replicated: Design, Tattoo, Body, 32, Color
(-83, 9), Shade (0), Trans (100)
- Top most flame, Rotate so that the darker of the two sides is completely
facing front, Enlarge two sizes up from smallest reduction, place as far
up the chest as it will let you go.
- The flame underneath that, Rotate so that the darker of the two sides
is completely facing front, Enlarge two sizes up from smallest reduction,
place underneath the previous flame so that it looks like one’s flowing
into the other.
- The flame underneath that, Rotate so that the darker of the two sides
is completely facing front, Enlarge two sizes up from smallest reduction,
place underneath the previous flame so that it looks like one’s flowing
into the other.
- The flames underneath that is on the leg, Rotate so that the darker
of the two sides is completely facing front, Enlarge ONE size up from smallest
reduction, place underneath the previous flame so that it looks like one’s
flowing into the other.
- The final flame underneath that is on the leg, Rotate so that the
darker of the two sides is completely facing front, Enlarge ONE size up
from smallest reduction, place underneath the previous flame so that it
looks like one’s flowing into the other.
- Repeat for the other side of the outfit.
Figure Body Morphing (70, 40)
Head – Left (-14, -23), Right (0)
Neck – Left (100, 100), Right (-100)
Chest – Left (100, 31), Right (5)
Shoulder (both) – Left (5, 62), Right (61)
Abdomen – Left (100, 72), Right (-14)
Arms (both) – Left (74, 79), Right (-52)
Forearms (both) (6, 17)
Hands (both) – Left (15, -23), Right (-71)
Waist (63, 62)
Thighs (24, 72)
Legs – Left (9, 20), Right (-46)
Feet – Left (-29, -7), Right (-43)
Height 6’3” (lower of the two 6’3” settings. I know it’s not accurate,
but this looks more in scale with in-game wrestlers)